I promised myself that if I bought this truck I would put a set of stacks on it.

Here’s what I am thinking….

Dual Chrome Shielded Stacks from JCWhitney.com

Unfortunately, there is a crossmember bolted to the lower frame rail to hold the carrier bearing on the dually.  I have to get the exhaust up and over this crossmember.  I could cut it up, but I don’t really want to disable the structural integrity of it…  So I’m going to need two pieces of 45° mandrel bent tubing for that section, plus a couple of 90 degree bends to get the exhaust into the bed and routed out to the dual stacks.

I can order the mandrel bends I need from mandrel-bends.com

Sources:

JC Whitney Hearthrob Exhaust Stacks:  http://www.jcwhitney.com/autoparts/ItemBrowse/c-10101/s-10101/p-100000315823/mediaCode-ZX/appId-100000315823/Pr-p_CATENTRY_ID:100000315823

Mandrel Bent Tubing pieces: http://www.mandrel-bends.com/

Copyright Kris Wickstead ©2009.  Always use good sense, the proper safety procedures, PPE and safe equipment.  Follow all manufacturers instructions.  For informational purposes only.  Not a guarantee of any kind.  Use information at your own risk.